Equator q series User's Guide download pdf (Page 11)

Equator Room Analysis User Guide v2.0

Setting Up Continued

To bypass room compensation without using Equator software, power down the monitor

and set ID Switch No. 8 to the down position. Power the monitor back on. This will restore

the factory defaults with the exception of user-applied tone contour. Previously

programmed tone contour data stays resident within the monitor until new tone contour

values are loaded from within Equator software.

DO NOT POWER ON MONITORS YET

Connect Audio Cables

Connect the outputs of the playback device or mixing console to the appropriate analog

audio input on the back of each monitor. Q Series monitors can accommodate both XLR

and ¼” cables that are wired for either balanced or unbalanced operation. For balanced

operation consult the Input Connector Wiring diagram located on the back panel of a Q

monitor.

DO NOT POWER ON MONITORS YET

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 27 28

No comments

Equator q series User's Guide Page 11