Equator q series User's Guide download pdf (Page 21)

Equator Room Analysis User Guide v2.0

Using Equator Room Analysis Software Continued

Selected Speakers

There are three buttons next to each displayed monitor. The select button chooses which

speaker’s compensation data will be displayed. In this case, the right speaker is selected

and its compensation data is displayed. Selecting the left speaker will display its data.

The compensation data was generated by the automated RRC calculation. Visual

compensation is to the lower left and the actual compensation values can be seen to the

lower right. Each value is user-editable either by double-clicking inside a cell and typing in

a new value, or by mouse-clicking the up/down arrows. This automated RRC data is

resident within each speaker, but has not been permanently saved and programmed.

Turning the speaker off at this point will negate this compensation. The saving &

programming process resides within Tab 9.

between the newly generated RRC calculation data and the previous data that was

programmed into the speakers.

There’s also a Phase Invert switch that reverses the phase of the selected speaker.

The Global Compare button at the top left corner of the screen allows an A/B comparison

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 27 28

No comments

Equator q series User's Guide Page 21