Equator q series User's Guide download pdf (Page 19)

Equator Room Analysis User Guide v2.0

Using Equator Room Analysis Software Continued

All enabled computer DAW input devices connected to the computer will automatically

appear within the Microphone Input Device drop-down menu. Select the appropriate

Microphone Input Device that the Equator measurement microphone is connected to

Select the microphone input channel as well. In this case channel 1.

The software automatically displays and enables the Equator model speaker networked.

By default, Speaker Group 1 is displayed upon launch. Speaker Groups are determined by

5 & 6 set to the down position (Group 1, renamed Stereo Setup). If multiple groups are

networked within a system, use the speaker group drop-down menu at the top of the screen

to switch to an alternative group. The speaker model number for any selected group will be

displayed in its appropriate speaker location (determined by ID Switch No. 1–6). If the

anticipated speaker does not appear, there is likely an error in the ID Switch settings and/or

network cable connections.

Select the DAW

Audio Output Device that is connected to the audio input on the back of

the speakers and select Channel 1 for the left speaker, channel 2 for the right speaker.

Click the test button and adjust the audio output device so there is a significant amount of

pink noise being heard through the monitors. Now adjust the microphone preamp input

level and make sure it is not clipping. Confirm that the microphone input meter within our

software has registered well into the green. If not, increase the output of the DAW device

until our meters do register well into the green, almost hitting red.

ID Switches No. 5 & 6. In this case, a pair of Q8’s networked together with ID Switch No.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 27 28

No comments

Equator q series User's Guide Page 19